Hi there,
I've seen a lot of info about the screws and pins but didn't see a picture with the measures of the hings of the rudder.
I`m intending to make a 3d drawing of it.
There are not many drawings of details about the rudder except these;
drawing hings
Moderator: Moderator
- maja
- Moderator
- Inlägg: 2795
- Blev medlem: 19 aug 2006 09:56
- Has thanked: 3 times
- Been thanked: 55 times
Re: drawing hings
The drawing displayed here is the only drawing of the kind that I have ever seen. It was published the first time in the Danish IF-boat magazine "IF-bladet" a couple of decades ago. The author was late Henrik Blomdahl, the former owner of "Muffe".
Marek, IF-båt SWE-829 "Ingela" från Lagunen i Malmö
Medlem i IF-båtförbundet sedan 1985
IF-båtägare sedan 1983
Medlem i IF-båtförbundet sedan 1985
IF-båtägare sedan 1983
Re: drawing hings
Just made a few drawings from it
- Bilagor
-
- Rudderhing2.PNG (97.79 KiB) Visad 5780 gånger
-
- rudderpin2.PNG (57.39 KiB) Visad 5781 gånger
Senast redigerad av 2 NED1417, redigerad totalt 19 gång.
- johan swe-1870
- Global moderator
- Inlägg: 2399
- Blev medlem: 24 aug 2006 09:43
- Segelnummer: 1870
- Båtnamn: InFinit
- Ort: Råå
- Has thanked: 106 times
- Been thanked: 58 times
Re: drawing hings
Great!
Would it be possible for you to zoom in on the hinge and the pintle parts? It is hard to read the measurements. Or can you make a pdf-file of the drawings?
Would it be possible for you to zoom in on the hinge and the pintle parts? It is hard to read the measurements. Or can you make a pdf-file of the drawings?
Johan Winberg, SWE 1870 InFinit
Re: drawing hings
It looks that I can NOT ad a pdf file to the message.
"Invalid file extension"
Is that common or for this message?
"Invalid file extension"
Is that common or for this message?
- johan swe-1870
- Global moderator
- Inlägg: 2399
- Blev medlem: 24 aug 2006 09:43
- Segelnummer: 1870
- Båtnamn: InFinit
- Ort: Råå
- Has thanked: 106 times
- Been thanked: 58 times
Re: drawing hings
You are quite right L-Å!
I just measured three old ones I have saved. The diameter is larger than 12,00 mm. It varies between 13,10 and 13,30 mm on those three, measured with a caliper.
Perhaps there are variants. Check for a press fit in the hinge part hole before making the pins!
I just measured three old ones I have saved. The diameter is larger than 12,00 mm. It varies between 13,10 and 13,30 mm on those three, measured with a caliper.
Perhaps there are variants. Check for a press fit in the hinge part hole before making the pins!
Johan Winberg, SWE 1870 InFinit
Re: drawing hings
I made the drawing by measuring old ones so there will probably be a difference in the sizes.
So be careful when you replace this part
So be careful when you replace this part